|
|
 |
Use Storbot 4 systems to automate carousel picking
and storing where high throughput, large container
size variations, and heavy loads are encountered.
Product
Range
The Storbot 4 offers one of
the largest container size capacities in the
industry.
- Container width: Up to
38-3/8 inches - 15 inch permissible range mixed
in same system
- Container length: Up to
38-3/8 inches - 17 inch permissible range mixed
in same system
- Container height: 24 to 3
inches - permissible range mixed in same system
- Container weight: 150
pounds maximum
- Handles most plastic,
steel, and cardboard containers
Standard
Features
-
 Parallel
jaw gripper
- Variable servo-controlled
gripper clamping pressure
- Precision linear bearings
on gripper clamp and reach axis
- All electric operation
- All axes servo controlled
- Spring-set platform
holding brake
- Chain break sensors and
catch brakes on masts
- Over-speed sensor
- Path-clear sensors
- Automatic chain take-up
- Powder coat finish
- Stainless steel bed
-
Controls
use UL listed components and are built in UL
certified panel shops
Optional
Features
- 3-axis servomotor
controlled
- Allen-Bradley PLC control
- Photo eye air blow-off
for dusty environments
- High temperature
operation
- Low temperature operation
- Larger tray/carton sizes
Specifications
- Up to six transactions
per minute
- Platform vertical axis
speed: 540 ft/min
- Platform vertical axis
acceleration: 10 ft/sec/sec
- Platform reach axis
speed: 2000 in/min
- Gripper clamp speed: 1500
in/min
- Vertical hoist chain
safety factor: 25
- Bearings: All pillow
block and flange bearings have a B1O life of
25,000 hours, and are a sealed, heavy-duty
design
- Footprint: 37 x 70 inches
to 37 x 82 inches depending on container size
- Height: Approximately
equal to the height of the top carousel shelf
plus 3 feet
- Storbot carousel
interface: The Storbot 4 is capable of accessing
up to two carousels stacked vertically. The
lowest shelf position is 14 to 16 inches from
the floor. The highest shelf position is
determined by the configuration of the carousel
bins. The Storbot can be positioned in-line, or
at a 45° angle with the carousel, depending on
requirements of the inbound and outbound
conveyor. The Storbot 4 features a pass-through
container handling design
|
|
